The Best Mono Amps of 2023

CLASS D AMPLIFIER - Class D topology ensures high efficiency with big power and a small footprint. This mono amplifier was built for driving subwoofers and subwoofer systems, maintaining the highest sound quality sound for your car audio.

BUILT FOR POWERFUL SOUND - Minimize heat generation with the PWM MOSFET power supply providing stability through the PC board. Old school Hifonics aluminum heat sink maintains superior heat dissipation to keep your car audio sounding smooth.

MADE TO LAST - Low noise preamplifier generates maximum low voltage signal from source unit, minimizing distortion. High temperature impact resistant inputs with hex screw terminals allow secure connections and are erosion resistant.

HIGH QUALITY CONNECTIONS - RCA outputs and a daisy chain multiple amplifier build eliminates additional signal cables from the source unit. Molded secure connections are used for all wires and angled for ease of access during installation.

CLASSIC HIFONICS LOOK - The ZXX Series maintains the classic feel of Hifonics amplifiers and include an illuminated logo on the front of the amplifier. The Hifonics logo illuminates when the amp is powered, making a statement even in the dark.

Features: Rockville RVA-M3 4000w Peak/1000w CEA RMS @ 1 Ohm Mono Car Amplifier, Metal Bass Remote Included, 1 Ohm: 1000 Watts RMS CEA Compliant (<1% THD @ 14.4 Volts) (74.1% efficient), 2 Ohm: 600 Watts RMS CEA Compliant (<1% THD @ 14.4 Volts) (84.5% effic

Peak: 4000 Watts @ 1 Ohm (Only use this power as reference if matching with amps that do not have an RMS rating), High-Speed MOSFET Power Supply, Class D Technology, Fully Adjustable 12dB / Octave Crossover with Differential Circuitry

Phase Control Switch, Full IC-Controlled Protection Circuitry, Adjustable 0-18dB Bass Equalizer, Mute and Delay Soft Start System, Status Mode LED Indicator, Minimum THD at Rated Power: <0.1%

S/N Ratio: >90dB, Under Voltage Protection at 9V, Over Voltage Protection at 16V, Radiation cooling keeps the amp running at high volumes for hours straight, Extruded aluminum heatsink, Frequency Response: 10Hz - 300Hz

Damping Factor: >150 @ 100Hz, Fuse: 40A*3, Technology: This series uses a reliable Class D circuitry that gives you the most reliability and the most power for your money, Dimensions: (L x W x H) 14" x 8.5" x 2.24", Weight:7.8 lbs

Includes: Amplifier. Bass Remote. Birth sheet with tested power. Owner’s manual. Mounting Screws. Warranty.

Rockville dB13 3000 Watt Peak/750w Dyno-Certified RMS Mono 2 Ohm Amplifier Car Amp. Dyno Certified RMS Power Ratings: (Certified Dyno Test / Less than 1 % THD) (Use these ratings when comparing with top brands such as Kicker, Rockford Fosgate, etc). - 2 Ohm: 750 Watts x 1 Channel <1% THD+N. - 4 Ohm: 450 Watts x 1 Channel <1% THD+N.

Peak: (Use these ratings when comparing with the top budget brands such as Boss, Power Acoustik, etc). - 2 Ohm: 3000 Watts x 1 Channel. - 4 Ohm: 1800 Watts x 1 Channel. High-Speed MOSFET Power Supply. Optical Coupler Class “D” Technology. Fully Adjustable 12dB / Octave Crossover with Differential Circuitry. Low Pass Filter: 50Hz - 250Hz. Subsonic Filter: 15Hz - 55Hz. Phase Control Switch.

Full IC-Controlled Protection Circuitry. Remote Dashboard Subwoofer Control. Fully Adjustable 12dB Bass Equalizer. Mute and Delay Soft Start System. RCA Preamp Line Output. 8 Volt Preamp Circuitry. Status Mode LED Indicator. Minimum THD at Rated Power: <0.1%. S / N Ratio: >90dB. Under Voltage Protection at 10V. Over Voltage Protection at 16V. Frequency Response: 15Hz - 250Hz.

Damping Factor: >150 @ 100Hz. 80 Amp Maxi Fuse. Dimensions: (W x H x L) 9" x 2.4" x 14.7"

G2 can be used as a sub amp or a mono channel amp. It has a mode switcher which can change between SUB and PBLT modes conveniently. Equipped with 19V 4.74A high quality power supply.

Applications: ① G2 can be used as a subwoofer power amplifier for passive subwoofers; ② G2 can be used as a mono amp to drive single channel. You can use two G2 to drive left and right channel separately, which are known as PBLT / BTL Bridge amp. Compared with normal 2.0CH amps, it can ensure totally no interference between two channels and can provide higher power.

It has a gain setting which allows 4-level of output level setting (20/26/32/36 dB). It can keep the purity of the sound and avoid the resistor influence. Besides, it also has a bass cutoff frequency control knob.

It adopts TI TPA3116 and NE5532 op-amp, which can offer 100W high power and can drive most home sub and mono speakers. Its optimized circuit can ensure totally no background noise. Besides, it also built-in speaker protection circuit and low pass bass filter.

Prompt and courteous customer service. For any questions you have, please feel free to contact us on Amazon.

【Hi-Fi Amp with Clean Sound Quality】Fosi Audio M03 subwoofer amp adopts the Instruments TPA3255D2 chip, High Efficient Power Output Up to 200Watt, providing 150 watts RMS into 4-ohm loads or 120watts to 8-ohm loads. Great amplifier to driver any bookshelf speaker or subwoofer.

【Subwoofer amplifier and Full-Frequency Mono Amp】Switch to PBTL, it's a Full-Frequency Mono amp for driving passive speakers and powered subwoofer. Switch to SUB, it's a subwoofer amplifier for diving passive and powered subwoofers.

【Mini Compact but Powerful】Built-in low pass filter for 20-300Hz subwoofers with SUB frequency control, small simple compact design but practical and powerful;

【Home Hi-Fi amplifier】Exclusively designed for the customers who pursue HiFi sound; MAX Power Output:200Watt. Note: Package comes with 32V/5A power supply, you need a more powerful power supply to get the MAX power output.

What You Get: M03 amp x1, 32V/5A power adapter x1, user manual x1, 18-Month global warranty, and 24-Hour quick customer service.

Efficient Class-D amplifier

Variable 12dB crossovers provides control to dial in perfect sound

KickEQ 6dB variable bass boost for those additional low frequencies

Variable 12dB crossovers provides control to dial in perfect sound

24dB subsonic filter for protection from potentially damaging frequencies

The BXX1200.1D is a 1200 watt mono amplifier featuring Super Class D technology with an NGSD digital chip to provide you with an extremely efficient, low temperature, high amplification system that others only dream about.

The rock solid Ultra-Fi MOSFET outputs are selected for both balance and output power. This keeps power smooth even during demanding peak in the music.

The amplifiers protection condition is also shown by blue illumination for normal operation and red for a short being present and requires the attention of an installer.

Max Power Rating: 4 ohms: 400 watts x 1 chan. 2 ohms: 600 watts x 1 chan. 1 ohm: 1200 watts x 1 chan.

Dimensions: 9"W x 13.25"L x 2.5"H, 1-year Manufacturer's Warranty

❤ 【Hi-Fi Amp with Clean Sound Quality】M02 subwoofer amp adopts TPA3116 chip, NE5532 op-amp, can provide 100watt output power for 4 ohm subwoofer or speaker. No pop, no audible noise, dead silent when nothing is playing through it.

❤ 【Full-Frequency and Sub Bass Switchable 】With a selector can be switched to subwoofer bass amplifier or full frequency mono amp, can be connected to passive suboower/speaker.

❤【Mini Compact but Powerful】Built-in low pass filter for subwoofers with sub frequency control, small simple compact design but practical and powerful.

❤【Home Hi-Fi amplifier】Home Hi-Fi mono integrated class d amplifier, Exclusively designed for the customers who pursue HiFi sound; Ship with 19V 4.74A power adapter.

❤【High Quality After-sale Service】 With 18 months warrenty and 24 hours after-sale service online to provide you the great shopping exprerience.

2,200 watts max

1,100 watts x 1 at 2 ohms

550 watts x 1 at 4 ohms

Frequency response: 10 Hz to 500 Hz

Super Class D technology powered by Ultra-Fi MOSFETs for high power, efficient cooling with minimal distortion

Awesome sound quality

Package Weight: 25.0 pounds

BANDA 15K Mono CAR AMP

Model Number: VIKING15000